The "gimp" family had two conflicting donor readings -- limp vs jump-jet --
flagged in 5.3.94 rather than guessed at. The binary settles it: LIMP. The
mode test in every gimp function is mech+0x40 in {3,4}, the same values the
damage model documents as "limp gait graphic (left 3 / right 4)"; there is no
jump-jet control anywhere in the pod cockpit; and the donor's port routing
("graphicAlarm 3/4") was the same field under a different name. Its
"run-jump clip" mech3 annotations were the misreading that started the murk.
RECONSTRUCTED, completing all 12 of mech2's census functions:
GimpLegClipFinished @004a7970 GimpBodyClipFinished @004a6344
AdvanceLegAnimationGimp @004a71f4 AdvanceBodyAnimationGimp @004a5bf8
+ the limp branch atop both normal *ClipFinished
+ the limp pick in Simulate (replaces the normal advancers while limping)
HOW A LIMP WORKS, now from the bytes rather than description:
It replaces ONE stride. Limping left, the right stride (6) hands off to
the left limp figure (0x16 -> the self-cycling 0x18) while the other leg
keeps its normal clips. The asymmetry IS the limp.
Both machines CLAMP THEIR DEMAND while in a cycle -- the leg machine
writes the mapper's own speedDemand cell down to the damaged side's cap
(new MechControlsMapper::SetSpeedDemand, matching the binary's direct
mapper+0x128 write), the body machine clamps bodyTargetSpeed, both floor
at zero. A limping mech cannot command more than its figure carries, nor
reverse out of a forward cycle.
The limp advancers keep states 0x16-0x1b LIVE -- the normal advancers
treat those as the reset group, which is exactly why the limp flavours
must be selected while limping or the figure is neutralized mid-cycle.
No death latch, no wind-down: the movement modes are exclusive.
ALSO EXPLAINED IN PASSING: Ghidra's 3760-byte FUN_004a6344 -- the census's
largest function -- is really THREE functions. The two normal ClipFinished
callbacks (@004a6928/@004a6d8c) are reached only via data pointers, so the
decompiler folded them into the gimp-body machine's extent.
All movement-mode reads route through Mech::MovementMode() (mech+0x40 == the
simulation state), which honours a BT_FORCE_LIMP=3|4 dev hook so the gait
could be verified before the damage model's limp hook exists.
VERIFIED, two runs on the rig:
NO-REGRESSION: the normal mission's speed sequence is BIT-IDENTICAL to
5.3.95 (7.31972, 26.6726, 22.1601, ...). The branch costs nothing.
FORCED LEFT LIMP (new pod_render_limp.conf): the mapper still demands
26.9; the hull lurches at 10-23. And on the wire the healthy walk's tight
pose-count pairs (650/649 ... 434/421) BREAK to a 3x asymmetry -- the
drag-leg joint at 18 poses against its partner's 55. The limp is visible
in the data exactly the way it will be visible on screen.
STILL OPEN in this family: the damage hook (leg zone >= 0.5 -> mode 3/4, a
MECHDMG increment -- nothing sets the mode in real play yet), and
IntegrateMotion's remaining pieces.
Co-Authored-By: Claude Fable 5 <noreply@anthropic.com>
CydandClaude Fable 5
7c2363d89f
